OVERVIEW
Power Button:
Push to open and push to close.
Torch Button:
Push to enable torch feature and push to close.
Led Group:
Those LEDs are used to indicate Power, Charge status,
Bluetooth device connection status and Data Rx / Tx communication
status on device. The power LED turns on when the power of the
device is on. The Bluetooth led is on when KMK118 is connected
to a Bluetooth device. Once the connection between the optical
probe and the Bluetooth device is established, the RX−TX LEDs
flashes whenever there is data transfer. Charge Led is on, when
you start charging the device. The LED will turn off when the
device is fully charged. The same LED will turn into red light, when
the battery voltage is low (when the device needs recharging).
PIN:
Standard PIN code «1234» for pairing Bluetooth device with
PC, HHU, Tablet or Cell Phone.
Micro USB Connector:
Any micro USB cell phone charger can be
used to charge KMK118 through this connector. This port also
behaves like Virtual COM Port (VCOM) in supported models when
connected to a USB Host device and can be used just like a cable
version of probe.
1
4
5
2
3
1
3
4
5
2
2 / 6
