Reebok 1410 Treadmill, Manual

32

Most treadmill problems can be solved by following 
the simple steps below. Find the symptom that 
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual. 

SYMPTOM: The power does not turn on

a.   Make sure that the power cord is plugged into a 

surge suppressor, and that the surge suppressor 
is plugged into a properly grounded outlet (see 
page 18). Use only a surge suppressor that meets 
all of the speci



 cations described on page 18. 

IMPORTANT: The treadmill is not compatible 
with GFCI-equipped outlets and may not be 
compatible with AFCI-equipped outlets.

b.   After the power cord has been plugged in, make 

sure that the key is inserted into the console. 

c.   Check the power switch located on the treadmill 

frame near the power cord. If the switch protrudes 
as shown, the switch has tripped. To reset the 
power switch, wait for 



 ve minutes and then press 

the switch back in. 

SYMPTOM: The power turns off during use

a.   Check the power switch (see the drawing above). 

If the switch has tripped, wait for 



 ve minutes and 

then press the switch back in.

b.   Make sure that the power cord is plugged in. If the 

power cord is plugged in, unplug it, wait for 



 ve 

minutes, and then plug it back in.

c.   Remove the key from the console, and then 

reinsert it.

d.   If the treadmill still will not run, please see the front 

cover of this manual.

SYMPTOM: The console displays remain lit when 
you remove the key from the console

a.   The console features a display demo mode, 

designed to be used if the treadmill is displayed 
in a store. If the screen shows a preset presenta-
tion when you remove the key, the demo mode is 
turned on. To turn off the demo mode, hold down 
the Stop button for a few seconds. If the demo 
mode is still on, see step 7 on page 27 to turn off 
the demo mode.

SYMPTOM: The incline of the treadmill does not 
change correctly

a.      Calibrate the incline system (see step 4 on 

page 29).

SYMPTOM: The iFit mode does not function 
correctly

a.    If the iFit mode is not functioning correctly, make 

sure that the treadmill has the most current firm-
ware available (see step 3 on page 29).

SYMPTOM: The treadmill will not connect to a wire-
less network

a.   Make sure that the wireless settings on your con-

sole are correct (see step 4 on page 30).

b.   Make sure that the settings for your wireless net-

work are correct.

c.   If your wireless network is set to use WEP encryp-

tion, try setting it to WPA or WPA2 encryption 
instead.

d.   If you still have questions, see the front cover of 

this manual.

 TROUBLESHOOTING

Reset

Tripped

c