ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call 1-800-445-2480.
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials.
Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver
, rubber
mallet
, and adjustable wrench
.
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses
shows the quantity needed for assembly.
Note: If a part is not in the hardware kit, check to see if it is preat-
tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic
parts, do not use power tools for assembly.
#8 x 3/4"
Screw (6)–6
#8 x 2 1/4" Screw (7)–4
3/8" Nut (11)–2
3/8" Star
Washer (8)–8
5/16" Star
Washer (9)–4
5/16" x 2" Bolt (2)–4
Extension Leg
Nut (10)–4
3/8" x 1" Bolt (4)–6
3/8" x 1 3/4" Bolt (3)–2
3/8" x 2 3/4" Bolt (5)–2
#8 x 1" Tek Screw
(1)–4
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown. Partially
fold the Frame (55) so that the treadmill is more
stable.
Do not fully fold the Frame until the
treadmill is completely assembled.
Attach two Base Pads (81) to the Base (85) with
two #8 x 1" Tek Screws (1).
85
55
1
81
1
6
81 1
