9
8. Slide the Left Base Leg Cover (82) over the end
of the Left Upright (111). Attach the Left Base
Leg Cover with three #8 x 3/4" Screws (6) and
two #8 x 2 1/4" Screws (7).
Be careful not to
overtighten the Screws.
With the help of a second person, carefully tip
the treadmill down so that the Base (85) is flat on
the floor.
6
111
82
85
8
9. With the help of a second person, hold the con-
sole assembly near the Left Upright (111) and
the Right Upright (113)
.
Connect the Upright Wire Harness (73) to the
Console Wire (119).
See the inset drawing.
The connectors should slide together easily
and snap into place;
if they do not, turn one
connector and try again.
IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN YOU
TURN ON THE POWER.
Then, insert the con-
nectors and the excess wire into the Right
Upright (113).
Insert the front ends of the brackets on the con-
sole assembly into the Right Upright (113) and
the Left Upright (111). Then, insert the rest of the
brackets into the Uprights.
Make sure that the
Wire Harnesses (73, 119) are not pinched.
73
113
111
Console
Assembly
9
7
73
Front of Bracket
119
119
