Reebok 910 Elliptical, Manual

20

HOW TO TURN ON THE POWER

IMPORTANT: If the treadmill has been exposed to 
cold temperatures, allow it to warm to room tem-
perature before you turn on the power. If you do 
not do this, you may damage the console displays 
or other electrical components.

Plug in the power cord 
(see page 18). Next, locate 
the power switch on the 
treadmill frame near the 
power cord. Press the 
power switch into the reset 
position. 

IMPORTANT: The console features a display demo 
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as 
you plug in the power cord and press the power 
switch into the reset position, the demo mode is 
turned on. To turn off the demo mode, hold down 
the Stop button for a few seconds. If the displays 
remain lit, see THE INFORMATION MODE on page 
25 to turn off the demo mode. 

Next, stand on the foot 
rails of the treadmill. Find 
the clip attached to the key 
and slide the clip onto the 
waistband of your clothes. 
Then, insert the key into the 
console. After a moment, 
the displays will light. 

IMPORTANT: In an emergency, the key can be 
pulled from the console, causing the walking belt 
to slow to a stop. Test the clip by carefully taking 
a few steps backward; if the key is not pulled from 
the console, adjust the position of the clip.

HOW TO USE THE MANUAL MODE

1.    Insert the key into the console. 

 See HOW TO TURN ON THE POWER at the left.

2.   Select the manual mode.

If the manual mode is not selected, press the 
Manual button on the console.

3.  Start the walking belt. 

  To start the walking belt, press the Start button, the 
Speed increase button, or one of the 1 Step Speed 
buttons numbered 1 through 12. 

 If you press the Start button or the Speed increase 
button, the walking belt will begin to move at 1 mph. 
As you exercise, change the speed of the walking 
belt as desired by pressing the Speed increase 
and decrease buttons. Each time you press one of 
the buttons, the speed setting will change by 0.1 
mph; if you hold down the button, the speed setting 
will change in increments of 0.5 mph. Note: After 
you press the button, it may take a moment for the 
walking belt to reach the selected speed setting.

 If you press one of the numbered 1 Step Speed 
buttons, the walking belt will gradually change 
speed until it reaches the selected speed setting. 
To select a speed setting that includes a decimal——
such as 3.5 mph——press two numbered buttons in 
succession. For example, to select a speed setting 
of 3.5 mph, press the 3 button and then immedi-
ately press the 5 button. Note: This will not function 
if the console is set to metric units.

 To stop the walking belt, press the Stop button. The 
time will begin to 



 ash in the display. To restart the 

walking belt, press the Start button or the Speed 
increase button.

Reset

Key

Clip