7
9. Orient the two Pulley Housings (26) as shown.
Slide the Eyebolt/Pins (51, 52) into a set of holes
in the Pulley Tubes (12).
Route the two Nylon Ropes (23) through the
Pulley Housings (26) as shown.
10. Insert the square tips on the two Rope Storage
Knobs (31) into the square holes in the Carriage
Plates (49, not shown). Attach the Rope Storage
Knobs to the Carriage (6) with two M6 x 61mm
Screws (47).
Route the Nylon Ropes (23) through the Rope
Grips (28). Pull on the Ropes so that they are
secure in the teeth on the Rope Grips.
Wrap the ends of the Nylon Ropes (23) around
the Rope Storage Knobs (31).
11.
Make sure that all parts have been properly
tightened. The use of the remaining parts will
be explained in ADJUSTMENTS, beginning on
the following page.
9
10
26
52
51
12
23
23
12
31
31
47
47
28
23
6
