6
2.
Press two 56mm Round Outer Caps (14) onto the
Rear Stabilizer (5).
Make sure the indents and the decal on the
Rear Stabilizer (5) are oriented as shown.
Attach the Rear Stabilizer to the Bench Frame (4)
with two M8 x 67mm Carriage Bolts (21) and two
M8 Nylon Locknuts (18).
Do not tighten the
Locknuts yet.
3.
Attach the Seat Frame (3) to the Bench Frame
(4) with two M8 x 63mm Bolts (25), two M8
Washers (20), and two M8 Nylon Locknuts (18).
Do not tighten the Locknuts yet. Make sure
that the bolt heads rest inside the holes in the
top of the Bench Frame.
4
5
20
20
3
2
24
18
7
6
7
Hole
18
26
20
20
24
2
3
4
18
18
5
21
4
3
18
20
25
20
Warning
Decal
Indents
4. Attach the Seat Frame (3) to the Front Leg (2)
with two M8 x 71mm Bolts (24), two M8 Washers
(20), and two M8 Nylon Locknuts (18).
Tighten the M8 Nylon Locknuts (18) used in
steps 1, 2, and 4. Then, tighten the M8 Nylon
Locknuts (18) used in step 3.
5. Orient a Backrest Frame (7) with the indicated
hole closer to the bottom of the Frame. Attach the
Frame to the Pivot Bracket (6) with two M8 x
43mm Bolts (26), two M8 Washers (20), and two
M8 Nylon Locknuts (18).
Do not tighten the
Locknuts yet.
Attach the other Backrest Frame (7) to the
Pivot Bracket (6) in the same manner.
14
14
