7
8. While another person holds the Pulse Sensor Bar (26)
near the Upright (4), connect the upper pulse wires to
the lower pulse wires. Insert the excess wire into the
Upright.
Orient the Pulse Sensor Bar (26) as shown. Attach the
Pulse Sensor Bar to the Upright (4) with four M8 x
16mm Button Screws (94), being careful not to
pinch the wires.
4
Upper
Pulse Wire
94
10
20
10
9. Identify the Front Center Pivot Cover (27). Attach the
Front Center Pivot Cover to the Frame (1) with four M4
x 16mm Screws (89).
Next, identify the Rear Center Pivot Cover (28). Attach
the Rear Center Pivot Cover to the Frame (1) with four
M4 x 16mm Screws (89).
Attach the Water Bottle Holder (23) to the Upright (4)
with four M4 x 16mm Screws (89).
9
8
26
28
4
27
89
94
94
Lower
Pulse Wire
Lower
Pulse Wire
Upper
Pulse
Wire
10. Apply a small amount of the included Teflon
®
lubricant
to a paper towel, and rub a thin film of the lubricant
onto both of the Pivot Shafts (10). Next, apply a small
amount of grease to the axle in the Upright (4).
Then, slide a 5mm Spacer (35) onto each end of the
axle in the Upright (4).
Next, slide the two Pivot Arms (20) onto the Pivot
Shafts (10), and turn the Pivot Arms so the flanges are
facing away from the elliptical exerciser. Then, slide
the Pivot Arms onto the ends of the axle in the Upright
(4); use a rubber mallet, if necessary.
Slide an M8 x 23mm Washer (103) onto an M8 x
25mm Patch Screw (123). Attach the left Pivot Arm
(20) to the left end of the axle with the Patch Screw.
Attach the right Pivot Arm (20) to the right end of the
axle in the same way.
89
89
89
89
20
Flange
10
23
89
Grease
Lubricate
4
35
123
103
Grease
