8
15.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
11. Identify the Left Handlebar (7). Attach the Left
Handlebar to the left Pivot Arm (20) with four M8 x
13mm Button Screws (90) as shown.
Attach the Right Handlebar (6) to the right Pivot Arm
(20) in the same way.
6
20
13.While another person holds the Console (17) near the
Upright (4), attach the Upper Wire Harness (58) and
the Pulse Sensor Wire (25) to the corresponding con-
sole wire harnesses. Then, attach the Console to the
Upright with four M4 x 16mm Screws (89), being
careful not to pinch the wires.
Attach the Upright Cover (22) to the Upright (4) with
two M4 x 16mm Round Head Screws (91).
4
13
12.Position the Front Left Pivot Cover (21) and the Rear
Left Pivot Cover (31) over the left Pivot Arm (20) as
shown. Attach the Left Pivot Covers with an M4 x
16mm Round Head Screw (91) and two M4 x 16mm
Screws (89).
Attach the Front Right Pivot Cover (29) and the Rear
Right Pivot Cover (not shown) over the right Pivot Arm
(not shown) in the same way.
31
12
11
90
7
29
21
91
20
90
89
14.Plug the Power Cord (56) into the Power Receptacle
(70) at the rear of the elliptical exerciser.
56
70
14
89
91
22
17
25
58
89
20
