ASSEMBLY
Assembly requires two people.
Set the treadmill in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench
and your own 7/16” and 9/16” wrenches
, rubber mallet
, wire cutters
,
and Phillips
screwdriver.
Use the part chart attached in the center of this manual to identify small parts used in assembly. Each
bag of hardware is labeled with the corresponding assembly step.
1. With the help of another person, carefully tip the treadmill
onto its
left
side. Have the other person continue to hold
the treadmill during steps 1 through 4. Note: Only half of
the hardware in the bags for steps 1 to 3 will be used. The
remaining hardware will be used at the end of step 4.
Identify the Right Upright (58), which contains the Wire
Harness (55). Insert the round tube on the Right Upright into
the Base (117) as shown. If necessary, apply grease to
the round tube and use a rubber mallet. Hold a Star Washer
(113) between the indicated tab and the Base, and
Finger
tighten
an Upright Bolt (66) through the tab into the Base.
Make sure that the two indicated Walking Platform
Screws (114) in the Walking Platform (100) are tight.
1
3. See the inset drawing. Identify the right Front Wheel (62)
by observing the direction that the Wheel Bracket (64)
slants.
Attach the Wheel Bracket (64) and the right Front Wheel
(62) to the Base (117) with four 3/4” Screws (12) as
shown.
Attach a Thin Base Pad (103) and a Thick Base Pad (75)
to the Base (117) with two 3/4” Screws (12) as shown.
12
103
12
117
64
75
3
62
117
114
58
100
55
66
113
Tab
64
62
Right
Left
6
2. Attach a Base Leg (78) to the Base (117) with two Base
Leg Bolts (77) and two Base Leg Nuts (70). Make sure
that the Base Pad (75) is in the position shown. (Note:
The Base Leg Nuts fit into square holes in the Base. If
necessary, push or pull on the Right Upright [58] to align
the holes.)
Do not fully tighten the Base Leg Bolts yet.
2
75
78
70
117
77
66
58
77
