8
Any revisions must first be approved by the product designer. Version: 201808
Revision By: JST
19.
SILICON APPLICATION
Mask the glazing channels and glass at the
intersections as shown. Apply clear silicon
to the
inside and outside
of the glass
panels. Remove the excess silicon.
Remove the masking tape immediately
after application.
20.
INSTALLATION OF BOTTOM DOOR SEAL
Trim to length if necessary. Clip onto the
bottom of the door. Ensure the sloping
face is inside the shower.
OPTIONAL DOOR SEALS
Two vertical edge seals are supplied with
the wall glazing channels. These may be
applied to the door opening edges (seals
are usually applied to the fixed panels).
Seals for the hinged side require being
trimmed to fit between the hinges.
Should these seals be required, it is
recommended to install them while
installing the glass and hinges.
Masking
Tape
TOP VIEW
3mm gap between
masking tape
Summary of Contents for Atlantis Glacier SFK-GL-HR
Page 1: ...SFK GL HR...
