page 17 of 19
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
Domaine Semi-Recessed Wall Hung
PREMIUM SOLID SIDED DRAWERS
REMOVING & INSERTING DRAWER
DRAWER FRONT REMOVAL AND INSTALLATION
To remove drawer front:
Turn centre screw
and pull drawer front forwards. Repeat on
other side.
First you will need to remove the Solid or LED drawer side:
Pull drawer all the way out then lift the front up,
a little force is needed to release the drawer
from the runner.
Extend drawer runners out and place drawer
on runners and push closed until it is about
2cm out from the vanity.
Apply a little extra force on the drawer front
(near the bottom of drawer) to push closed.
and connect runners in place.
The drawer should then be automatically
connected to the runner by the two catches.
Listen for a click!
With a screw driver push
into the lug to realease the
side and start pulling up.
Pull the drawer side up and off with
both hands, sliding off the fixing
brackets. Repeat on both sides.
Identify plastic lugs - lugs
are at the back of the drawer
on each side at the top.
TOP VIEW
DRAWER FRONT
To replace drawer front:
Align front panel with
drawer sides, apply some pressure at the
bottom on both sides and push in to secure.
Slide the drawer sides down onto the fixing
brackets until the lug secures side in place.
Repeat on both sides.
Depending on width of drawer you may need
to unscrew and remove middle bracket on the
under side of the drawer.
REMOVING
INSERTING
CLICK!
DRAWER HEIGHT ADJUSTMENT
LATERAL ADJUSTMENT
TILT ADJUSTMENT
Remove ADP cap to access screws.
Turn the back screw to adjust the height of the
drawer front. Turn clockwise to go up and
anti-clockwise to go down.
To move drawer front to the right, turn right
screw clockwise and left screw anti-clockwise.
Turn the opposite way to move to the left.
To tilt drawer front, turn adjustment screws
on inside of drawer at the front and back, on
both sides.
page 6 of 8
