PowerLift by ReechCraft
16
2.2
Preparation, Inspection, + Maintenance
Pre-start Inspection
The pre-start inspection should include each of the following:
PREPA INSPECTION
SECTION
2
• Cleanliness
- Check all surfaces for leakage, debris, or foreign objects.
•
Decals and Placards
- Check for cleanliness and legibility. Make sure none of the
decals or placards are missing. Make sure all illegible decals are cleaned or
replaced. Refer to Section 5.1 for decal contents and locations.
•
Safety and Service
- Make sure a copy of the Operator’s Safety Manual is
enclosed in a weather resistant container.
•
Setup
- Make sure the machine is set up in accordance with Section 3.4.
•
Walk-around Inspection
- Refer to Section 2.3.
•
Drill Selection Criteria
- Refer to Figure 3.2.
•
Function Check
- Once the walk-around inspection is complete, perform a
function check of all systems in an area free of all overhead or ground-level
obstructions. Refer to Section 2.4 for additional information.
