14
Selecting Thermocouple Type (tYPE)
Follow steps 1 and 2 when "tYPE" appears on the LCD.
1. Press the and buttons to select between type K and J.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
Selecting the Temperature Unit of Measure (t-CF)
Follow steps 1 and 2 when "t-CF" appears on the LCD.
1. Press the and buttons to select between °C and °F.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
Setting the Data Logging Sampling Rate (SP-t)
Follow steps 1 and 2 when "SP-t" appears on the LCD.
1. Press the and buttons to to adjust the sampling rate between 0,
1, 2, 5, 10, 30, 60, 120, 300, 600, 1800, and 3600 seconds.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
Formatting the SD Card (Sd F)
Follow steps 1 through 5 when "Sd F" appears on the LCD.
1.
Press the and buttons to select "YES" to format the card. Select
"NO" to abort.
2. Press the
ENTER
button to confirm selection.
3. Press the
ENTER
button again to re-confirm.
4. The meter will format the SD card and automatically return to the
Setup menu when formatting is complete.
5. Press the
ESC
button to exit the Setup mode and resume
normal operation.
Note:
It is recommended that new SD cards should be formatted prior to
first use. If the formatting process fails, the meter will display -E-.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
