11
Setup Mode
1. Press and hold the SET button for 2 seconds to enter Setup Mode.
2. Press the SET button continuously to scroll through the
following parameters.
Parameter
Description
dAtE
Set the time and date
SP-t
Set the data logging sampling rate
PoFF
Enable or disable the auto-power off function
bEEP
Turn the beeper on or off
dEC
Set the decimal format (USA (20.00) or European (20,00))
Sd F
Format the SD memory card
t-CF
Select the temperature unit of measure (°C or °F)
tYPE
Select thermocouple type (K or J)
3. Once the appropriate parameter has been selected, follow the
instructions below.
Note:
The meter automatically exit out of the Setup mode if no key is
pressed within 7 seconds.
Setting the Time and Date (dAtE)
1. Press the
ENTER
button when "dAtE" appears on the LCD.
2. Press the and buttons to adjust the year as indicated by "YY."
3. Press the
ENTER
button to confirm selection.
4. Repeat steps 2 and 3 for month, day, hour, minute and seconds as
indicated by (mm/dd/h/m/s).
5. After each value has been selected and confirmed, the meter
will automatically skip to the next parameter.
Note
: At any time, you can press the
POWER
button to exit the Setup
mode and resume normal operation. The internal clock will keep accurate
time when the meter is powered off. When new batteries are installed the
clock will have to be reset.
continued...
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com
