Reed Instruments R8100SD, Instruction Manual

14

Verify Set Time, Date and Sampling Rate

During normal operation press the 

TIME

 button to display the year, 

month, day, hour, minutes and selected sampling rate.

Data Logging

Data Recording Modes

Manual Data Logging:

 Press the 

LOG

 button to manually log up to 

99 readings on a SD memory card (see 

Manual Data Logging Mod

e for 

full setup instructions).

Automatic Data Logging: 

Setup the meter parameters in order to 

automatically log data on a SD memory card. The number of data points 

is limited by the size of the memory card.

Note:

 It is recommended to use a class 4 SDHC memory card between 1Gb 

and 16Gb. Insert the SD memory card in the slot at the bottom of the meter. 

The card must be inserted with the label side facing the rear of the meter.

Manual Data Logging Mode

In manual mode, the LOG button is pressed to manually log a reading on 

the inserted SD card at any time. In order to setup the meter for manual 

data logging, follow steps 1 through 5 below.
1.  Set the data logging sampling rate to "0" seconds (see 

Setting the 

Data Logging Sampling Rate

 for details).

2.  Press and hold the LOG button for 2 seconds at which point the 

lower portion of the LCD will display P-X (X = memory position 

number between 1 and 99).

3.  Press the   and   buttons to select one of the 99 data memory 

positions in which to record.

4.  Press the LOG button again to save a reading to memory. "REC" will 

flash each time a data point is stored. 

Note:

 If a card is not inserted or the card is defective, the meter will flash 

"Sd -E-". In this case, power the meter OFF and try again with another SD 
memory card or verify that the card is correctly inserted.
5.  To exit manual data logging mode, press and hold the LOG button 2 

seconds to resume normal operation.

continued...

REED Instruments

1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com