reedinstruments
www
com
Pantone 485 & 123
485 = (0/100/100/10)
123 = (0/18/100/0)
How to obtain Emissivity? con’t
Contact.the.Type.K.probe.to.the.object.surface.and.test.the.temperature.
of.same.point.with.IR.measurement..After.both.values.are.stable,.press.
UP or DOWN button for confirmation. Then, emissivity of the object will be
shown.at.the.upper.side.of.the.LCD.
Press.MODE.button.or.trigger.to.enter.normal.measurement.
Notes:
1..When.the.IR.value.is.not.corresponding.to.the.TK.value,.or.IR.and.TK.
tested.the.different.points,.no.emissivity.will.be.obtainable.or.a.wrong.
emissivity.will.be.obtained.
2..The.temperature.of.the.target.should.be.higher.than.the.environment.
temperature..Normally,.100°C.is.suitable.for.obtaining.a.higher.accuracy.
emissivity..After.obtaining.the.emissivity,.if.the.difference.between.the.IR.
value.(in.the.middle.of.LCD).and.TK.value.(at.the.lower.side.of.LCD).is.
too.big,.the.obtained.emissivity.will.be.incorrect..It’s.necessary.to.obtain.
a.new.emissivity.
Data Logger
Storing Data
Your.thermometer.is.capable.of.storing.up.to.20.data.locations..The..
infrared.temperature.and.temperature.scale.(°C.or.°F).are.also.stored.
Infrared
To.store.data.from.an.infrared.reading,.pull.the.trigger..While.holding.the.
trigger,.press.the.MODE.button.until.LOG.appears.in.the.lower.left.corner.
of.the.display;.a.log.location.number.will.be.shown..If.no.temperature.has.
been.recorded.in.the.shown.LOG.location,.4.dashes.will.appear.in.the.
lower.right.corner..Aim.the.unit.at.the.target.area.you.want.to.record,.and.
press.the.laser/backlight.button..The.recorded.temperature.will.appear.
in.the.lower.right.corner..To.select.another.log.location,.press.the.up.and.
down.keys.