45
8. Commissioning
a) Unfold Over-Roll Bars, Remove Car Body
Step 1:
Remove the safety clips on the left and right of the vehicle, see
arrows in the figure on the right (figure shows left side of the
vehicle).
Step 2:
Pull out the long safety pin right behind the front axis (below the
car body, close to the steering mechanics).
Step 3:
Remove the two black, L-shaped plastic brackets above the ve-
hicle front.
Step 4:
Remove the car body front.
Then fold back the entire rear (with overroll bracket and car bo-
dy).
Observe that the grip for the rope pull starter is guided through
the car body opening so that it cannot catch at the car body.
For assembly of the vehicle, proceed in reverse order.
The rear spoiler is delivered separately from the vehicle. Fasten
it to the vehicle with the enclosed assembly set.
The nuts are pushed into small openings below the rear spoiler
holder. Then put the rear spoiler on the rear spoiler holder.
Push the screw through the washer and the plastic holder and
fasten the rear spoiler to the vehicle.
2
1
3
4
Æ
Æ
Summary of Contents for 490150
Page 142: ...142 ...
Page 143: ...143 ...
