10
9. Setting up the Transmitter
In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries
The power supply of the transmitter requires 2 AA/mignon batteries (e.g. Conrad Item No. 652506, please order 2x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
Loosen the attachment screw (1) of the battery compart-
ment lid (2) at the back of the transmitter with a suitable
screwdriver.
Push the latching lever (3) of the battery compartment lid
down slightly and fold open the battery compartment lid.
Insert two type AA/mignon batteries with correct polarity
(observe plus/+ and minus/-) according to the specifica
-
tions at the bottom of the battery compartment (4). The
spiral-shaped spring contact (5) always must be con-
nected to the minus pole of the battery.
Replace the battery compartment lid in the transmitter
housing and let the latching lever latch.
Then tighten the attachment screw again.
Figure 2