37
„POI-Mode“
The mode is only available if the switch „IOC“ has been programmed to the combination B or C.
The „point of interest“ can only be saved manually. The prerequisite for this is reception of more than 6 satellites for
a period of at least 10 seconds.
To manually save the „point of interest“, the switch „IOC“ must be switched back and forth between the front/upper and
the middle position in combination C 3 - 5 times.
In combination B, the switch „IOC“ must be switched back and forth between the middle and the rear/lower positions
3 - 5 times.
When the „point of interest“ has been saved successfully, the status LEDs flash yellow quickly 20 x.
14. „Go-Home“ Function
The quadrocopter has a „Go-Home“ function that returns the quadrocopter to the starting point automatically or by
remote control command. The prerequisite for this function is that the starting point has been saved (see „HL-Mode“)
and that the quadrocopter is flying in „GPS-Mode“ and receives more than 6 GPS satellites. The distance between
the quadrocopter and the saved starting point must be more than 5 m as well.
When the switch „Go Home“ is put in the rear/lower position for the return function, the quadrocopter will turn more
or less and hover for approx. 3 seconds.
When the quadrocopter is below a flight altitude of 20 m, it will first climb to 20 m before flying back over the saved
starting point. If it is at a flight altitude above 20 m, it will return to the starting point at once.
Figure 29
Summary of Contents for 1400004
Page 1: ...Operating Instructions Quadrocopter Shadow 2 0 RTF Item no 1400004 Version 10 16 ...
Page 16: ...16 9 Transmitter Controls Figure 7 ...
Page 58: ...58 ...
Page 59: ...59 ...
