43
20. Binding Function
Transmitter and receiver in the quadrocopter are already aligned with each other (bound) in the factory and can
be used at once. Renewal of binding is only required after replacing the receiver in the model, when replacing the
transmitter or to remove a malfunction, e.g. when the receiver parameters are no longer displayed in the transmitter
display.
Attention!
When the transmitter is reset to the factory settings, the binding must be renewed, since the receiver ID has
also been deleted.
Re-establishing the binding:
To recover binding between the transmitter and model, the four propellers must be removed and the top of the housing
of the quadrocopter must be screwed off. For this, the landing frame must be removed and the 20 screws at the bottom
of the housing turned out.
The four screws below the motors do not need to be removed, since these screws only hold the motors.
• Transmitter and receiver must be in direct proximity (distance
approx. 50 cm).
• Switch off the transmitter.
• Disconnect the two plug connectors (1) with which the quadro-
copter is connected to the receiver from the receiver.
• Connect the enclosed programming plug (2) to the „B/VCC“
connection of the receiver with the cable loop.
• The receiver must be supplied with power via a receiver bat-
tery that is connected to any output of the receiver (3). Ensure
correct polarity. The minus connection (-) must be at the bot-
tom.
• Switch on the receiver. The red LED in the receiver (4) starts
to flash quickly.
• Push the button „BIND/FOLLOW“ (5) at the transmitter and
keep it pushed.
• Switch on the transmitter with the on/off switch (6) with the bin-
ding button pushed. Then release the „BIND/FOLLOW“ button
at the transmitter.
• The display briefly shows „RXBinding“ and, at correct binding, „RXBind OK“. Then the display switches to operating
display.
• The red LED in the receiver remains lit and binding is completed. If the LED flashes red, binding was not successful
and must be repeated.
• Switch off the receiver and then the transmitter.
• Remove the programming plug and connect the two plugs of the quadrocopter to the receiver again.
Figure 33
Summary of Contents for 1400004
Page 1: ...Operating Instructions Quadrocopter Shadow 2 0 RTF Item no 1400004 Version 10 16 ...
Page 16: ...16 9 Transmitter Controls Figure 7 ...
Page 58: ...58 ...
Page 59: ...59 ...