53
b) Basic Trim „Subtrim“
As already mentioned when trimming in the quadrocopter, it may happen in manual mode („GPS“ off) that the quad-
rocopter will fly in a specific direction even though both control sticks are in the middle positions. The four trim buttons
(see figure 7, items 5, 7, 15 and 17) can be used to trim the quadrocopter so that it has a stable hover flight again
when the control sticks are not deflected.
The basic trim can be used to pre-trim the quadrocopter so that the quadrocopter hovers stably again while the trim
displays (see figure 10, items 5, 6, 8 and 10) are back in the middle positions.
Important!
Before setting the basic trim, check with the operating display whether the four trim displays are set cen-
trally.
Setting the Basic Trim
• Switch on the transmitter and call the function setting menu.
• Move the cursor arrow to the menu item „Subtrim“ with the two
buttons „UP“ and „DOWN“.
• Briefly push the button „OK“ to activate the menu item.
In the display you will see display items for the six control func-
tions with the respective currently set trim values.
• Push the buttons „UP“ or „DOWN“ to select the base trim for
channel 1.
• Brief pushing of the button „OK“ will cause the cursor arrow to
jump to channel 2. If the button „OK“ is pushed and held, the
factory parameter will be called.
• Push the buttons „UP“ or „DOWN“ to select the base trim for
channel 2.
• Repeat this process until you have set the desired basic trim in
all ten channels.
• Keep the button „CANCEL“ pushed for a longer period to save
the settings. The display then shows the function setup menu
again.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
Figure 44
Summary of Contents for 1400004
Page 1: ...Operating Instructions Quadrocopter Shadow 2 0 RTF Item no 1400004 Version 10 16 ...
Page 16: ...16 9 Transmitter Controls Figure 7 ...
Page 58: ...58 ...
Page 59: ...59 ...