67
12. Binding Function
To enable transmitter and receiver to work together, they must be bound by the same digital code. In the delivery state,
transmitter and receiver are aligned with each other and can be used at once.
The binding settings must be renewed mainly after a replacement of the transmitter or receiver or to remove any
interferences.
Before you can bind the receiver to the transmitter, check if the transmitter works in the right digital code (see previ-
ous chapter).
To perform the binding procedure, proceed as follows:
• Transmitter and receiver must be in direct proximity (distance approx. 50 cm).
• Switch off the transmitter.
• Disconnect any servos that may be connected from the receiver.
• Connect the enclosed programming plug to the "BAT" connection of the receiver.
• The power supply of the receiver (receiver battery or speed controller with BEC) is connected to any output of the
receiver.
• Switch on the receiver. The receiver LED starts to flash quickly.
• Press the binding button at the receiver (1) and keep
the button pressed.
• Switch on the transmitter with the on/off switch with
the binding button pushed. The LED display in the
transmitter starts to flicker.
• When the LED in the receiver flashes slowly after a
few seconds, binding, binding has been completed.
• Release the binding button at the transmitter.
• Switch off the receiver and transmitter and remove the
programming plug.
• Re-connect the servos/controllers to the receiver.
• Check the function of the system. If the system is not
working properly, perform the process again or check
the digital code of the transmitter.
Figure 24
1
