19
c) Flight Movements
After the model has been started, it is in hover flight. Push the left control lever at the transmitter forward carefully. This
initiates rising of the model. Put the left control lever into the middle position again to stop rising. Pull the left control
lever back carefully to start sinking. Put the left control lever into the middle position again to stop sinking.
If you move the left control lever to the left, the model will turn around its vertical axis. If you move it towards the right,
the quadrocopter will turn to the right.
Push the right control lever forward carefully. The model is controlled forward. If you push the right control lever back-
wards, the quadrocopter will be controlled backwards.
If the right control lever is controlled to the left, the model will float to the left. If you move the right control lever to the
right, the quadrocopter will float to the right.
When controlling the model, also observe the notes in chapter 11.
d) Flip Function
The model can perform a flip (a 360° turn). For this, put the quadrocopter into a stable hover flight at an altitude of at
least 1.5 metres at sufficient distance from the pilot and any obstacles.
Now push the right control lever (figure 11); push the control lever like
a conventional button.
The transmitter will emit a control sound at an even rhythm to confirm
that you have chosen flip mode. The control sound will remain acti
-
vated until the flip is completed.
Now, briefly put the right control lever in the direction in which the flip
is to take place.
Examples: If you push the right control lever forward, the quadrocopter
will turn over forwards. If you push the right control lever backward, the
quadrocopter will turn over to the right.
After you have specified the flip direction at the transmitter, put the right control lever into the neutral position again
at once.
Attention!
The flip function generally must only be used if the model is flown in a large hall/in a large room or outdoors,
is in a stable flight condition (hovering) before the respective operating button is pushed at the transmitter,
the flight height is not below 1.5 metres and the quadrocopter is at least 5 metres away from obstacles and
persons. If this is not observed, there is a danger of damage to the model or other objects nearby and a
danger of injury to persons/animals in the vicinity from contact or crash!
When the model is already in "Low Batt mode" (LEDs at the quadrocopter flash), the flip function is deacti
-
vated for reasons of safety and therefore cannot be performed.
The model can perform a flip function only in one direction (only forward or backward; only to the left or
right) and therefore also requires the corresponding clear control commands from the transmitter (right
control lever forward or back; right control lever to the left or right). Therefore, avoid inadmissible control
commands when the flip function is activated, such as "right control lever pushed to the front+left". In such
cases, there may be uncontrolled flight conditions and crashes.
After a flip, the function is automatically deactivated at the transmitter. If you want to perform another flip,
you need to activate the flip function at the transmitter first.
Figure 11
