19
Nod trimming:
If the quadrocopter tries to drift forward, reduce the speed until the quadrocopter is safely on its landing struts again.
Push the bottom trim button for the nod function several times (also see figure 1, item 2).
Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift forward.
If the quadrocopter drifts to the rear, push the upper trim button for the nod function.
Every time the button is pushed, the trim is adjusted by one step and the adjustment is confirmed by a
brief signal. If the button is pushed and held, the transmitter will continually emit a sequence of signals to
indicate graduals adjustment of the trim. When the final position of the trim is reached, the transmitter no
longer emits any sounds.
Approx. 60 trim steps are available in either direction. The trim middle setting is indicated by a longer signal
sound.
Figure 13
The trim setting for the nod and roll function is not saved. After switching the transmitter off and on again,
the trim is reset to the middle position.
Attention!
If the trimming is misadjusted very far, the position sensors must be calibrated. The required procedure is
described in a dedicated chapter in the course of the instruction.