53
b) Switching on the transmitter
Slide the joystick for the pitch and yaw function (9) to the
lowest position (see dark arrow).
Slide the on/off switch (see also Figure 1, no. 7) from the
left position (OFF) to the right position (ON).
The transmitter emits a short beep. The blue LED function
indicator will glow steadily (see also Figure 1, no. 13). The
red LED function indicator (see also Figure 1, no. 3) will
flash slowly.
Push the joystick for the pitch and yaw function completely
forward (see light arrow) and then back to the lowest posi-
tion (dark arrow).
The transmitter will emit two short beeps and the red LED
function indicator will go out.
Then, switch off the transmitter again using the on/off switch.
If the power supply is no longer sufficient for proper operation of the transmitter, the red LED indicator (see Figure 3,
no. 3) will start to flash slowly and the remote control will repeatedly emit alarm beeps in double rhythm.
In this case, stop flying the quadrocopter immediately and insert a new set of non-rechargeable batteries into the
transmitter.
Figure 3
Summary of Contents for 1719347
Page 37: ...37 Bild 28 ...
Page 77: ...77 Figure 28 ...
Page 118: ...118 Figure 28 ...
Page 158: ...158 Afbeelding 28 ...
