47
8. Final assembly of the quadrotor helicopter
a) Assembly of the radial arms
The model is delivered in flat-pack form. Firstly, click
the four radial arms (1) into flying position. Then
squeeze the clips on the central frame (2) slightly
apart from one another and click the radial arms
upwards (definite clicking into place noticeable).
Should you wish to dismantle the radial arms again
for transportation, you should press the clips on
the central frame slightly apart from one another to
avoid tearing.
Should you not wish to dismantle the
radial arms again for transportation, you
can also permanently affix these using
superglue or cable clips.
b) Assembly of the landing legs
Click the landing legs (1) into flying position. Defi-
nite clicking into place of the retaining clips (2) into
the slots (3) should be noticeable.
For folding, you should slightly push the retaining
clips (2) into the slots (3) using a small screw driver,
in order to avoid breaking the plastic parts.
A red direction indicator is mounted to one of the
landing legs. This direction indicator should always
be considered as the "in front" flight direction.
For hard landings, please attach the landing legs. This is normally expected by us. Should you wish to
avoid this effect or you no longer wish to fold away the landing legs for transportation, you can also
permanently affix the landing legs using superglue.
Figure 2
Figure 3
Summary of Contents for 208000
