26
Important!
Always turn the remote control on before switching on the drone. When turning off the devices, always remove the
battery from the drone before turning off the remote control.
Before inserting the battery into the drone, ensure that there are no other active 2.4 GHz remote controls (e.g. for
another drone) in the immediate vicinity.
When you have inserted the battery, the LED lights on the drone and the remote control
will flash.
Push the throttle lever (8) to the top (you will hear a beep) and then pull it down to the
bottom. Another beep will sound when they are successfully paired and the LED lights
on the drone and remote control will stay constant.
The drone is now ready for take-off.
Important!
The internal stabilization components are calibrated during the pairing process. Do not move or rotate the drone
during this time.
If the LED light on the remote control continues to flash, this indicates that the pairing process has failed. Repeat the
process again with the throttle lever (8) as described above. If the problem persists, try turning both devices off and
on and initiate pairing with the throttle lever.
1
Resetting the gyroscope
Before your first flight and whenever the drone appears to be unbalanced in flight, you
can reset the gyroscope using the remote control. Pull the throttle and steering levers
at a 45-degree angle for 2 to 3 seconds and then release. The gyroscope is reset when
the flashing LED lights on the drone stay constant.
After resetting the gyroscope, reboot the model by turning the remote control and drone
(remove/reinsert battery) off and then on again. You will also need to pair the drone with
the remote control before you can use the model again.
Important!
Read the following information carefully before flying the drone.
d) Basic information on controlling drones
Before flying the drone, familiarise yourself with the control functions to ensure that you can control the drone safely.
The drone is controlled using the two levers on the remote control. These have the following functions:
