26
5. Safety instructions
The guarantee/warranty will be void if damage is incurred resulting from non-compliance with
the operating instructions. Liability for any and all consequential damage is excluded!
We do not assume any liability for damage to property or personal injury caused by improper
use or the failure to observe the safety instructions! In such cases the guarantee is voided.
Normal wear and tear during operation (e.g. worn tires) is excluded from the guarantee and
warrantee, the same is the case for accidental damage (e.g. broken off transverse link, scratched
or destroyed car body etc.).
Dear Customer, these safety instructions are not only for the protection of the product but also for your
own safety and that of other people. This is why you should read this section very carefully before using
the product!
a) General information
• The unauthorized conversion and/or modification of the product is inadmissible because of safety and approval
reasons (CE).
• The product is not a toy and should be kept out of reach of children under 14 years of age!
• The product must not get damp or wet.
• Taking out a private liability insurance is recommended. If you already have one, get some information whether the
operation of a model is covered by your insurance.
• Do not leave packaging material unattended. It may become a dangerous toy for children!
• Should questions arise that are not answered with the help of this operating manual, contact us (contact information
see chapter 1) or another expert.
The operation and the handling of remote control model cars must be learned! If you have never steered
such a vehicle, drive especially carefully and get used to the reactions of the car to the remote control
commands first. Do be patient!
b) Operation
• Every time before you use the product, make sure that no other models are operated with the same frequency within
the range of the transmitter. The control over remote controlled vehicles will get lost! Always use different frequencies.
• With every operation, the settings of the trim regulator for forward/reverse drive as well as those for steering must be
checked, and if necessary, modified.
This is why the wheels of the car must not be placed on the ground yet when the car is put into operation. Place the
vehicle on a suitable surface that allows the wheels to turn freely (don’t put your hands in the drive!).
After that, adjust the trim so that the motor no longer turns when you let go of the lever for forward/reverse operation
or until the steering assembly is straight (the precise settings for driving straight can be carried out later on whilst
driving).
