61
Then the rear control arms prepared as
described in chapter 7. d) can be installed.
The following parts are required:
2x lower bolts "G"
2x upper bolts "H"
2x drive shafts "I"
2x floating wheel axles "J"
2x ball bearings "K1"
2x tapping screws 12mm "L"
2x shock absorbers "M"
J
K1
I
M
G
H
L
L
H
L
G
H
J
G
I
J
M
I
F
M
F
The two lower control arms of the rear axle are installed at the lower control arm holders on the chassis using two bolts
"G". Pay attention to the alignment of the left and the right control arm!
If you have not already done so, properly insert a ball bearing "K1" into each axle leg each and insert the floating wheel
axles "J" through the ball bearing into the axle legs. Insert the drive shaft "I" between the differential and the floating
wheel axle "J". Now attach the two upper control arms using a bolt "H" for each.
Install the two shock absorbers "M" at the lower control arm using a tapping screw "L" (thread length 12 mm). Attach
the shock absorber to the left and the right control arm at the same positions/holes.
At the top of the shock tower, the shock absorbers are screwed onto the thread of the Allen screw "F" (see last page;
a suitable flat spanner is required).
Summary of Contents for 23 67 28
Page 158: ...158 ...
Page 159: ...159 ...
