45
13. Commissioning the model aircraft
The model is controlled using a 2.4 GHz remote control. The receiver should be electronically connected
to the transmitter for the model to respond to the control commands from the transmitter. This connection
is established when the transmitter is switched on. It is therefore essential that you follow the power-on
procedure listed below.
a) Switching on the model aircraft
Fully charge the flight battery and insert it into the model
according to the procedure described in section 9.
Slide the on/off switch on the model (see also Figure 5, no.
4) to the “ON” position (= switched on).
The LED on the receiver electronics (1) starts to flash
quickly. Then position the model horizontally on a level
surface.
Before switching on the transmitter, push the joystick for
the drive motors (see also Figure 6, no. 1) to the rear posi-
tion (motor off).
Then use the on/off switch (see also Figure 6, no. 4) to
switch on the transmitter. The transmitter LED starts to
flash. The receiver electronics LED will now glow steadily.
To activate the motor control, push the joystick for the
drive motors all the way forward and then immediately
back to the rearmost position.
The transmitter LED will now glow steadily as well.
The model is now ready for take-off.
Figure 13
Summary of Contents for 2373336
Page 55: ...55...