41
10. Transmitter controls
1 Joystick for the drive motors
2 LED indicator
3 Direction control joystick
4 On/off switch
Unlike the direction control joystick (3), which is held in the
middle position by spring force, the joystick for the drive
motors (1)
always
remains in the last set position. In addi-
tion, this joystick has a very fine pitch that can be felt when
it is moved forwards and backwards.
11. Using the transmitter
a) Inserting the batteries
The transmitter is powered by 3 Mignon/AA batteries.
Use only batteries (1.5 V/cell) and do not use recharge-
able batteries (1.2 V/cell) as the power supply for the
transmitter.
To insert the batteries, proceed as follows:
Loosen the retaining screw (1) on the battery compart-
ment cover (2) on the back of the transmitter with a suit-
able screwdriver.
Push down the locking latch (3) of the cover lock to the
side and lift off the battery compartment cover.
Insert 3 Mignon/AA batteries according to specifications
on the bottom of the battery compartment (4), observing
the correct polarity. The spiral spring contact (5) must
always be connected to the negative pole of the battery.
Replace the battery compartment cover and allow the
locking mechanism to lock into place in the transmitter
housing.
Then tighten the retaining screw.
Figure 6
Figure 7
Summary of Contents for 2373336
Page 55: ...55...
