62
9. Checking the Configuration
a) General Information
Please carry out the configuration of the QuadroCopter as described. Programming of the channels is essential, since
otherwise the QuadroCopter will not recognise your transmitting equipment. When you have carried this out, your
QuadroCopter is ready to fly.
If you are using a computer remote control, programme it without using a mixer in the standard wing program! To
correctly align the pilot stick for the desired control commands, it is necessary to familiarise the QuadroCopter with the
used transmitter.
In the process, the QuadroCopter’s electronics system memorises which channel which control command broadcasts.
Generally, you can freely choose the configuration of the control lever (according to your habits), however, it is
recommended that beginners follow the recommended examples.
Ex factory, the QuadroCopter is configured to mode 2. The examples are for a common assignment used by many
model pilots. Decide which configuration you wish to program and carry out the familiarisation of the channels
correspondingly. Further possibilities for control mode 1, 3 or 4 can be found in the instructions in this chapter under
the heading „possible control modes“. The standard transmitter illustrated in this chapter is not part of the delivery and
is just as suitable for operation as a computer transmitter.
For monitoring the configuration, indicating malfunction or operating status, a red and a green LED are installed on the
flight control „QC09“. The respective indications can be seen in the following chapters 11 and 12 of these instructions.
When using multiplex remote controls, the servo protocols must be adapted for all four functions (throttle,
roll, pitch and yaw) from „MPX“ to „UNI“.
Summary of Contents for 450 ARF QC09
Page 166: ...166 ...
Page 167: ...167 ...
