49
• Function #5, green LED flashes 1x long: Maximum braking strength
The speed controller unit allows proportional braking strength depending on the setting of the transmitter lever.
A high setting (e.g. 100%) decreases braking distance but has a negative effect on the lifetime of the drive (drive
pinion gear, main gear, differential, tyres).
c) Resetting the Speed Controller
This function will reset all settings that were adjusted when setting up the speed controller unit can be returned to the
original factory settings.
Proceed as follows:
• Switch on the transmitter. Leave the throttle/brake lever
at the transmitter in its neutral position and do not move
it.
• Switch on the speed controller (move the slider (1) in
the „ON“ direction). The vehicle should now be ready for
operation; no LED is lit on the speed controller.
• Press and hold the setup button (2) (more than 3 se
-
conds) until the red and green LEDs at the speed cont-
roller flash slowly at the same time.
• The two LEDs go out after a few seconds.
• Now switch off the speed controller (push the slider to the „OFF“ position). All settings are now reset to the factory
setting, see table in chapter 10. b).
For reprogramming of the speed controller, observe chapter 10. a) and 10. b).
Important!
If you use LiPo batteries to operate the vehicle, check the basic settings of the speed controller for whether
undervoltage protection is activated (usually 3.0 V/cell). With the undervoltage recognition deactivated, the
LiPo batteries will otherwise suffer deep discharge and be destroyed.
If NiMH drive batteries are used in the vehicle, deactivate the undervoltage recognition.
Æ
OFF ON
1
2
Summary of Contents for Bad Boy 1271058
Page 118: ...118 ...
Page 119: ...119 ...
