11
9. Using the transmitter
The numbers used in these operating instructions refer to the figure alongside the text or the figures within
the respective section. Cross references to other figures are indicated with the corresponding figure num
-
ber.
The figures of the remote control and the model in these operating instructions are for illustrative purposes
only. The label, design and colour scheme of the products supplied in series may differ completely from the
figures in these operating instructions.
a) Inserting the non-rechargeable batteries
The transmitter is supplied by 2 Micro/AAA non-rechargeable batteries.
Important!
Use only non-rechargeable batteries (1.5 V/cell) and do not use rechargeable batteries (1.2 V/cell) as the
power supply for the transmitter.
To insert the non-rechargeable batteries, proceed as follows:
Push the locking latch of the cover lock (1) on the under-
side of the transmitter forward and lift off the battery com-
partment cover (2).
Insert 2 Micro/AAA non-rechargeable batteries (3) accord-
ing to the specifications on the bottom of the battery com
-
partment (4), paying attention to the correct polarity. The
spiral spring contact (5) must always be connected to the
negative pole of the non-rechargeable battery.
Replace the battery compartment cover (2) again and al-
low the lock to snap into place in the transmitter housing.
Figure 2
Summary of Contents for Foldable Drone G-Sense
Page 1: ...Operating Instructions Electrical quadrocopter Foldable Drone G Sense RtF Item No 1697439 ...
Page 41: ...41 ...
Page 42: ...42 ...
Page 43: ...43 ...