Reely HT-5, Operating Instructions Manual

9

10.    Setting up the Transmitter

  In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures 

within the section. References to other figures are indicated with the corresponding figure number. 

a) Inserting the Batteries

For the power supply of the transmitter you will need 4 

alkaline batteries (e.g. item no. 652507, pack of 4, order 1) 

of the size AA/mignon. 

Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of 

the transmitter. Press the corrugated area (2) and push off 

the lid downwards.
Ensure that the polarity is correct when inserting the 4 bat-

teries. A corresponding note (3) is located on the bottom 

of the battery compartment.
Then slide the lid of the battery compartment back on from 

the bottom until the locking mechanism engages. 

b) Switching on the Transmitter

When new batteries are inserted, switch on the transmitter 

with the function switch (see figure 1, item 8) for test pur

-

poses. For this, slide the operating switch from the bottom 

(off) to the top (on). 
The transmitter emits a short signal sound and the LED 

display (also see figure 1, item 7) lights up green perma

-

nently.
If the voltage supply drops below 5.0 V, the LED display 

switches from green to orange to red and thus indicates 

threatening undersupply of the transmitter. The model 

should then no longer be operated. When the voltage 

drops below approx. 4.0 V, the LED display starts flashing 

red and the transmitter emits acoustic warning sounds at 

regular intervals. In this case, operation of the model must 

be ceased as quickly as possible. Insert new batteries for 

further operation of the transmitter.

After you have verified the correct function of your trans

-

mitter, switch it off again.

Figure 2

Figure 3