27
Digital coding „AFHDS 2A“
The remote control transmitter enables you to control receivers with the digital code „AFHDS 2A“ and „AFHDS“. Ex
works, the transmitter is set to the enclosed „AFHDS 2A“-encoded receiver.
If you want to operate a REELY receiver with the digital code „AFHDS“, the transmitter must be switched first and then
the receiver must be bound to the transmitter. More information on binding of transmitter and receiver can be taken
from chapter 16: Binding Function.
To switch the digital code at the transmitter, proceed as follows:
• Call the „RX Setup“ menu.
• The menu item „AFHDS 2A“ is already selected and can be
activated with the button „OK“.
• The buttons „UP“ or „DOWN“ switch the digital encoding
„AFHDS 2A“ off. The display shows „Off“.
• Pushing the button „OK“ saves the setting and the display
shows the digital code „AFHDS“.
• Push the button „CANCEL“ repeatedly until you get back to
the operating display.
• Then perform binding.
• Switch back to „AFHDS 2A“ according to the same principle as
described above.
If the transmitter works with the digital code „AFHDS“, the
menu „RX Setup“ only shows the digital code as a setting
option. Only when the transmitter code has been set back to
„AFHDS 2A“ will the menu „RX setup“ have all menu items
available again.
Figure 22
Summary of Contents for HT-6
Page 1: ... Remote Control HT 6 2 4 GHz Item no 1310037 Version 04 15 7 ...
Page 69: ...69 ...
Page 70: ...70 ...
Page 71: ...71 ...
