12
8. Preparations for flying
a) Inserting batteries into the remote control
Remove the battery compartment cover on the back of the
remote control. Slide the cover in the direction of the arrow
(A) and lift the cover off the compartment.
Insert two AAA batteries in the correct polarity (B). Pay
attention to the markings on the battery compartment.
Replace the battery compartment cover in the correct po-
sition.
Using rechargeable batteries is not recom-
mended due to their lower voltage (disposable
batteries = 1.5 V, rechargeable batteries =
1.2 V) and their tendency to self discharge (the
remote control would quickly indicate that the
batteries are empty).
The remote control only uses a small amount
of electricity, therefore disposable batteries will
last for significantly longer. We recommend us
-
ing high-quality alkaline batteries.
b) Charging the quadcopter battery
Use a USB power adapter, USB cigarette lighter, comput-
er USB port or a USB hub with its own power adapter (not
included) to power the USB charger. This must be able to
deliver an output current of at least 500 mA.
Switch off the quadcopter.
Connect the USB connector on the USB charger (B) to
the USB power supply, and then connect the small con-
nector (C) on the USB charger to the "CHA" socket (A)
on the model.
Charging will begin provided that the battery is not defec-
tive (high impedance/disconnected) and the charger is
connected to a power supply. The red LED indicator on
the USB battery charger lights up to indicate that the bat-
tery is charging.
•
Constant: Battery is charging
•
LED off: The battery is full/fully charged
Figure 1
Figure 2
Summary of Contents for Pocket Drone FPV
Page 1: ...Operating Instructions Electrical quadrocopter Pocket Drone FPV RtF Item No 1642774 ...
Page 38: ...38 ...
Page 39: ...39 ...