31
9. Operation
a) Removing the vehicle body
The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be taken off.
b) Installation of receiver aerial cable
The receiver aerial cable is normally rolled up on delivery. Unroll the aerial cable completely and smoothen it carefully.
Run the aerial cable through the aerial tube and stick the aerial tube into the aerial mount on the vehicle.
A rubber cap might be enclosed for the aerial tube. Place it on the tip of the aerial tube to prevent the cable from
moving out of position.
Make sure the aerial cable does not get into the drive mechanism.
Never shorten the aerial cable, which would reduce the range. Do not coil up the cable if it does not fit
into the aerial tube! Just let it hang loose from the top of the aerial tube.
c) Inserting the battery pack into the vehicle
Caution!
The battery pack must not be connected to
the speed controller yet!
To insert the battery pack, open the battery compartment
cover (A) on the underside.
First pull the holding clip (C, see arrow in upper illustration)
from the retaining pin (B). Then pull out the retaining pin.
Now insert a rechargeable battery pack. The connecting
cable of the battery pack is installed upwards through the
opening (on the side of the connector of the speed controller).
Re-attach the battery compartment cover (A) properly, stick
the retaining pin (B) into the opening (either from the right
or from the left) and lock the retaining pin using the holding
clip (C) previously removed.
C
B
A
¨
Figure 2
