-6
-
-5
-
B.
This machine uses a value consistent with the nameplate power outlet must be
grounded port.
C.
Remove the power cord and reliably , securely plugged into a power outlet.
D.
Make sure the machine 's inlet and outlet is not blocked or blocking other objects.
Ensure the inlet and outlet of the machine can effectively play the smooth performance of the
machine and reduce electricity costs .
E.
Before Switch to air purification model,you should Install in the HAPE fliter or Activated
Carbon Fliter in side the air intake frame.
（ ）
Running lights :
After power- beep is heard, the machine into standby mode, and
this does not light , turned on, the lights lit , after the shutdown , the lights off . ( Note: The
standby display digital display profit or humidity )
（
2
）
Water full indicator:
When the water tank is full ( ie, magnetic switch off ) , the
machine automatically standby , the lights flash , the buzzer sounds five beeping . Water full
signal disappears , then automatically the original mode, the compressor 3 minutes effective
protection .
（
3
）
Continuous running lights :
In continuous mode , the lights lit , the other states ,
this lamp is off .
（
4
）
Defrost indicator:
When entering this light Always defrost operation , defrost
termination or other states , this lamp is off .
（
5
）
Air purification lights:
Anion lights are only lit when it is enabled , other state off.
（
6
）
The lamp timer setting :
Press time setting key to set the timer switch , the light
flashes, the setting is complete or in timing.
1
※
Preparing the Unit for Use
※
A. The placement of the machine :
The machine can be placed in the figur e requires full
play to its performance.
F.
In order to avoid the repeated water tank caring,It is in strongly recommendation that to
extend the draining to ground if this unit would in long term running.if the outlet pipe get
wrapped or deflated,it would resulte bad water follow and even cause dead machine.
REFINE-DEHUMIDIFIERS
REFINE-DEHUMIDIFIERS
※
Lamp operation
Remove the air intake frame
then Install the HAPE fliter
or Activated Carbon Fliter in
Put External pipe through
the Vias on radiator cap
and connect it to the water
pipe which been fixed on
water collector
≥
≥
≥
≥
