-7
-
-8
-
6. Tank operations Notes
1 ) After the machine stops running when pulling the tank to maintain a steady water tank
removed.
2) While moving the tank ready to pour with both hands to hold up the bottom of the
tank.
3 ) Do not move and damage the tank float .
※
※
Maintenance and Repair
WARNING!
Be sure to turn off the power before for maintenance to avoid accidents !
Because of the air filter is easy to accumulate dust , blocking the air intake passage ,
thereby affecting the dehumidification
effect , therefore, must be regularly
cleaned.
If the machine is in larger dust places,
should be cleaned once a ~ 5 days .
If the machine is used in relatively
clean environment can be cleaned once a
month.
Clean the filter method :
1.Remove the filter,Filiter may be
cleaned by Vacumming or By washing with warm water(no soap or Solvents),Insure
Fliter is dry prior to Restarting unit
2. Make Tank Empty and Unplug the Unit when it is not in using.
3. Do not use the machine near the stove , heaters and other heat sources or air
outlet of places, so as not to affect the dehumidifying effect or danger.
4. Do not use machine in where have Water Splash potential problem,to prevent
the leakage of dangerous
5. After the machine should be placed firmly before use, to prevent dumping, to
1. Clean the filter
Filter
REFINE-DEHUMIDIFIERS
REFINE-DEHUMIDIFIERS
※
Use Instructions
※
1 . " On / Off " Button :
a.Press this
" "
Button, the unit will start running .
b.Press this
" "
button again,the unit will stop running .
※ Preferably stand for 3 minutes , so that the remaining water droplets on the
evaporator flows into the water tanks .
Please unplug the power cord after the machine is turned off to save standby power
consumption and avoid the risk of accidents .
2 ."Up" and "Down" Button
Used to adjust the set humidity , also used to adjust the timing shutdown and timing for
the start of the set time.
• Humidity setting adjustment range :
Between 35 to 90 percent , up or down button
once for each 1% , when the set humidity < 35% , digital display "C0" enter the continuous
dehumidification mode , the first power-on defaults "50 %." ( Note : Continuous
dehumidification mode not affected by humidity )
• Time setting adjustment range :
00, 01 to 24 hours, up or down button once every 1
hour , 00 digital display indicates the timing when setting off or regular boot cancellation or no
timing settings.
Note: The regular boot and shutdown timing not both timing and timing is
automatically canceled after a power failure , do not remember.
3
.
Air Purifier :
Press the button, air purification function is activated .
4
.
Anion :
Press this button to start the anion .
5. Time off and Time on operations
Boot mode, press the " timer setting " key to start the timer off function , digital timer
flashes set the time, The display number of initial timing is 00,press the arrow keys to adjust
the settings within 5S(no flashes when Hold the Up/Down key continuously).adjusted to the
time required and leave your finger from panel,said the setuo is completed after 5S with no
touch ,display back to present condition humidity
.
( Note : In standby mode, press the "
timer settings " button to start the timer on function )
Always one Buzzer sound with every successful key pressing,only one Buzzer sound
as weel as to continuously press when finger left to Button.
