preventing its withdrawal. There can also occur heat transference through the pin
which destroys the rubber O-ring.
The O-ring can only be changed when the brass T-piece is removed from the stove.
When the stove is not burning and the burner pot has oil in the bottom, it can
easily be drained off by pulling the cleaning pin right out. The excess oil will
then run out and the remainder can be easily wiped out with a piece of rag before
the stove is relit.
12. LIGHTING THE STOVE
IMPORTANT! IMPORTANT! IMPORTANT!
Check that the burner pot is free of oil, see safety precautions.
Fill the fuel tank with oil and open the tank cock and the safety fuel valve.
A safety valve should always be mounted on the oil control or on the fuel supply
line. It is very important always to shut of the safety valve when you shut off
the stove. On this oil control there is only one shut-off valve on the outlet
side to the burner in the stove. Therefore, there will still be oil pressure in
the oil control itself even if you shut off the stove with the knob on the oil
control.
Important: When the stove is not in use, the safety valve should be turned off
and left in the closed position.
The control indicator off on the regulator should be set to 1. Open the top of
the stove and drop a lit match down into the bottom of the burner pot.
If methylated spirit is used to light the stove, approx 5 cc should be poured
directly into the burner pot and a lighted match thrown into the stove, allow the
stove to burn for 2/3 minutes before switching the fuel oil supply (regulator)
on.
Important Safety Advice. Do not look directly into the stove from above when
using this start method.
Close the top of the stove and wait 5-10 minutes, the time it takes for the stove
to heat up and set light to the fuel oil. The control indicator can then be
turned to the required from 1 to 6 on the scale.
Remember to start the circulating pump if the stove is coupled to a central
heating unit.
SAFETY PRECAUTIONS BEFORE LIGHTING THE STOVE
NEVER LIGHT
1. A stove that has been extinguished and is still hot.
2. A stove with a frozen central heating unit.
3. A stove with any oil in the burner pot. If in doubt remove the cleaning
pin and drain the burner pot before attempting to light the stove.
Carelessness with point 2 and 3 can cause explosion.
Before lighting the stove for the first time, check that the “turbo”, burner
gauze or burner rings are correctly installed. (see drawing).
13. MAINTENANCE
A correctly installed oil stove requires a minimum of cleaning: 1-2 times per
winter.
THE STOVE REQUIRES CLEANING WHEN:
1. The stove will not burn with a pure clean flame, and soot deposits
occur in the burner.
Summary of Contents for 2000K
Page 1: ...Tel 49 0 40 8890100 www toplicht de Schiffsausr ster...
Page 3: ......