UM-0203
Rev 1.1
14 | P a g e
3.8
Stretcher Mode
The following steps outline the procedure to convert the FROG-XT6-P into stretcher mode.
The FROG-XT6-P can accommodate two stretchers, either both at the same time or one on
its own.
Converting to Stretcher Mode
i.
For one stretcher, fold down the two seat backs
behind buoyancy panels A and B (seats numbers 1 &
4).
ii.
For two stretchers, fold down the two seat backs
behind buoyancy panels A and B (seats numbers 3 &
6) and the two seat backs behind buoyancy panels C
and E (seats numbers 2 & 3).
iii.
Use one 13mm spanner/socket, to remove the two fittings on each seat as indicated
below and fold down each seat (Note: pinch hazards). There is one fitting on each
side of the seat to remove.
iv.
These bolts are then replaced in the cross holes on both sides as indicated below.