Page 2/2
Display Overview & Easy Start
Speed Search
(CON71)
Bit #
1 During general acceleration
2 Initialization after a fault
3 Restart after instantaneous power
interruption.
4 Starting with power on
2c)
The mode button sequences
through the above modes, 'PAR'
and 'CNF' are used in this guide.
1. POWER UP
Multi-Key
Function
:
N:
None
U: User Group
FWD,
REV
2b)
Press
8 times
scrolling
to '61'
3. EXECUTE "EASY START" FUNCTION
Operating Status:
STP: Stop
FWD: Forward
See manual for full list
Speed
Reference:
K
: Keypad
V: V1 Input
See manual
for full list
Navigating Parameters:
With
displayed, press right
arrow to sequence through
parameter groups. (DRV, BAS,
ADV, etc.
)
Use down arrow to
acces any code within each
group.
2. INITIATE "EASY START" FUNCTION
2a)
press
4 times
Press
The parameters below will be sequenced as shown in the order below after user input for
each. The parameters in
red
listed below have additional details shown at the bottom of the
page. Please refer to the User Manual for more details.
Be ready to enter the value for the parameter code shown:
1)
Macro selection
7)
Fault Restart
(PRT08)
2) 60/50Hz
(BAS10)
8) Motor Voltage
(BAS15
)
3) Motor Capacity in HP
(DRV14)
9) Retry Number
(PRT09)
4) Rated Motor Current
(BAS13)
10) Power On Resume (COM96
)
5) Motor Poles
(BAS11)
11)
Speed Search
(CON71)
6) Line Voltage
(BAS19)
12) CMD Source (use default)
13) Freq. Ref Src. (use default)
Fault Restart (Auto Restart on Power Loss)
(PRT08)
Use
Bit:
on
off
Bit 0: fault trips excluding
Low Voltage - move to high
position
Bit 1: fault trip
exclusively for Low
Voltage - move bit to
high position
When you see this screen,
you have completed quick
start and are ready to run in
auto mode
. If the start
command is landed on P1,
cycle power,
and basic set
up is complete. Please refer
to the manual for PID set
To Operate the VFD in Hand Mode:
Multi-directional key is used to
select the speed in Hz.
The motor will start accelerating
Initial
display at
power up
Start
Command:
K
:
Keypad
T: Terminal
Block
See manual
for full list
The Easy Start option should appear on
initial
power up. Select YES to enter the Easy Start
menu and proceed to step 3.
If it does not appear on the first startup, then follow steps 2a,
2b, 2c.
This function will set up motor data, permit selection of a macro, and configure automatic
restart criteria. If you are using an analog speed reference, and are using P1 on the terminal
block, this will permit operation in auto mode in only a few minutes.
14 times
scrolling
to '40'
press
& select
Press
cycle
power, easy
start function
will begin
Macro Select
If you see an application in the macro list that fits
your needs select it, if not then select Basic.
Be aware the PID controller is enabled for all
selections except Constant Torque.
If you want to run Easy Start again, simply repeat step 2 & 3.
Bit #
4 3 2 1
Summary of Contents for MD100H Series
Page 1: ......
