Manual - TC.P Quadro
TopControl application
2016-08-05
187/330
V04.52
6
6.4.7.2. Tab
– <STATUS>
User level: from Standard User
The <STATUS> tab indicates important values in an overview, such as
voltages, currents and temperatures. In addition, the occurrence of er-
rors and warnings is indicated by class.
1
2
3
4
5
6
7
8
9
10
Fig. 109
Parameters on the <STATUS> tab.
STATUS tab
– parameter description
1
Actual state,
read-only indication
Indicates the actual system status of the master module or slave module,
depending on the selection in “Source selector”
-8-
.
For further information on system states, see Table 47, page 79.
2
Output,
read-only indications
The actual values for the output voltage, output current and output power are
displayed. The actual value
s are dependent on the selection in “Source selec-
tor”
-8-
.
3
Sense,
read-only indication
The sense power indicated is calculated from the sense voltage measured
and the actual current. (Actual current dependent on
-8-
).
4
System output,
read-only indication
The system parameters indicated (system output voltage, output voltage and
output power) are determined from the type of configuration in the multi-unit
system.
5
Internal device actual values,
read-only indication
Indication of the device internal primary current (DC intermediate circuit to the
output transformer) and the heat sink temperature for the IGBT and rectifier
bridges. The indication is dependent on the selection in Source selector
-8-
.
The table is continued overleaf.
