Manual - TC.P Quadro
TopControl application
2016-08-05
199/330
V04.52
6
Conditions for AAP and user-defined curves
To be able to edit and create curves, certain conditions must be met.
1
2
3
4
5
Fig. 117
Condition for opening the windows for editing user-defined and
AAP curves.
Conditions for user-defined and AAP curves
1
Used Function Blocks,
group
“General enable” in “General Setup” group must be selected.
At least one selection from Voltage, Current or Power must be made.
If a selection is not made or “General enable” is cleared,
none
of controls in the “Function Block” group box for editing are available.
2
Functions Block,
group
Depending on the “Used Function Blocks”
-1-
selected a corresponding func-
tion block can be selected in the list box.
The selection made here defines the reference value for the Y axis in the edi-
tor window
-5-
.
3
Base Function,
group
One of the following entries must be selected in the list box
User defined:
The label for
-4-
changes to “Edit user defined...”
AAP curve:
The label for
-4-
changes to “Edit AAP...”
4
<Edit user defined...>/<Edit AAP>,
button
The button changes its label and its function to suit the selection in
-3-.
A window for editing curves is always opened using the button.
5
Window
Depending on the selection in
-2-
and
-3-
the window for user-defined or AAP
curves opens.
Table 115 Parameters as a condition for user-defined and AAP curves.
