Manual - TC.P Quadro
Analogue interface
2016-08-05
145/330
V04.52
6
6.2.
Analogue interface
Short description of the analogue interface
The operation of the analogue interface is defined by the pin definition
for the analogue interface X105.
Set values can be specified by applying a reference voltage to the in-
puts for U, I, P, R on the analogue interface.
Pin definition
of the analogue interface X105
For further information see chapter, 3.2.4.7, page 64.
Activation
of the analogue interface for
remote programming
For further information see chapter 3.3.3, page 73.
Utilisation of the Multi Rack Controller (MRC)
Operation of the master devices in several multi-unit systems to
form a large multi-unit system.
For information of the multi-unit system, see chapter 5 page 131.
6.3.
HMI and RCU
6.3.1.
Case designs
The HMI and RCU are available in three different forms
Fig. 79
Installation forms for the control unit (HMI/RCU)
Case designs for HMI/RCU
1
HMI, Human Machine Interface
Directly built into the front panel on the single TopCon power supply
2
RCU front panel, Remote Control Unit
Built into a system cabinet, as front panel with 2 U
3
RCU device, Remote Control Unit
Remote Control Unit is built into a dedicated case with 2 U
Table 73 HMI/RCU - different forms
1
2
3
