Manual - TC.P Quadro
Safety and hazards
2016-08-05
15/330
V04.52
1
1.1.6.
Transport area
TopCon power supplies are always supplied with 2 strong carrying han-
dles (steel sheet). These handles are inserted in the slots in the side of
case and make it possible to transport the device easily.
Fig. 3 Attaching the carrying handles supplied to transport a
TopCon power supply (here 9 U).
Due the high weight it is advisable to carry the device between 2 people
and whenever possible to use a trolley.
Remove the carrying handles after transporting the TopCon power sup-
ply and store them in a safe place.
During the transport of systems the following is to be noted:
It is not allowed to tip the system by more than 20 degrees! Larger tip-
ping angles could cause mechanical damage to the carrying frame and
the TopCon front panels. As a rule, the doors on the case for the sys-
tem should be closed during transport so that the case can absorb
higher loads.
On moving the system using a forklift truck:
Depending on the design of the system, the cabinet plinth is reinforced
with a strong steel frame. This frame is suitable for transport using a
forklift truck. It is imperative you pay attention to an adequate contact
area and fork overhang!
Take into consideration that the centre of gravity may be high depend-
ing on the system!
There is a risk of tipping!
Secure the system against slipping and tipping using fastening
gear.
