Manual - TC.P Quadro
TopControl application
2016-08-05
219/330
V04.52
6
“Control” group – parameters
5
New/Load/Copy and close configuration,
submenu
“New ...”:
Add a new scope configuration file. The <SCOPE> tab is set
to the default values.
“Load ...”
1
:
Loads a scope configuration with its data onto the <SCOPE>
tab from the computer’s file system.
Alternatively drag & drop can be used.
An entry is added to the list box.
“Copy ...”
1
:
The actual scope with its data is copied and indicated as a
new configuration file.
“Close ...”:
Actual scope is closed after a conformation prompt.
6
Save configuration,
submenu
The following save options can be selected:
Only scope configuration parameters
Scope configuration parameters & data
Scope configuration parameters & data as copy
7
Manage configuration,
submenu
The “Scope configuration Manager” window is opened. In this window configu-
ration files can be loaded, saved and deleted.
To select files: click the related line using the left mouse button.
8
Set as reference signal,
submenu
The reference signals are for comparisons that can be indicated in addition to
the actual signal data set.
Reference signals are shown dotted on the scope display.
9
Update addresses
2
,
submenu
If configurations were created for a different firmware version, the address
allocation for the variables indicated may no longer be correct. Using this
menu item the addresses for the selected channel signals are applied from the
gridfile/var file to be selected (and therefore the related destination addresses
corrected).
Table 130
Parameters in the “Control” group
1
Scope file is included in the list box. See Fig. 123, page 207.
2
If the scope configuration actually displayed does not match the firmware, a
warning is output. Contact support!
