Manual - TC.P Quadro
Control
2016-08-05
73/330
V04.52
3
3.3.3.
Analogue control (X105)
3.3.3.1. Activation of the analogue interface for remote control
The analogue interface can be activated via all the interfaces in the de-
vice, and also via the analogue interface itself.
Activation of the analogue interface without HMI for remote control
The analogue interface is activated via itself.
Activation is via pin 20 on the digital input on the analogue interface by
means of the following signals:
Rising edge from 0 V to 24 V.
If the ANALAOG_REFERENCE_SELECT signal has already
reached the high level of 24 V on power-up.
For information on the pin definition see Table 40, page 65.
Pay attention to the interface hierarchy.
Activation of the analogue interface with HMI (option)
for remote control
Using the “analogue” selection in the HMI, the control over the system
can be transferred to the analogue interface.
If this setting is to be retained on the next system start, to save the set-
tings the RS-232 interface and the TopControl application must be
used.
The HMI interface does not have any feature for saving settings.
